How to Match a Subwoofer and Amplifier: A Kiwi Car Audio Guide
You know the feeling. Your favourite track comes on, you turn it up, and the factory speakers just rattle and fade. A proper subwoofer changes that. Suddenly the bass line rolls through the seat, the kick drum hits your chest, and the music finally sounds like it does in your head.
Getting there means pairing the right sub with the right amplifier, though. RMS, peak watts, ohms and voice coils can feel like a puzzle. This guide explains each one in everyday terms, so you can build a setup that sounds great and lasts, whether you're keeping it simple or chasing serious doof.
Quick answer
Match the amplifier's RMS output at your sub's final ohm load to the sub's RMS rating, and always compare RMS, not peak. A sub with dual 4-ohm coils can be wired to 2 or 8 ohms. Then build the box to the size the sub recommends and choose a wiring kit thick enough for the amp: 8 gauge for small amps, 4 gauge for mid-size and 0 gauge for big builds.

What does each part of a car audio upgrade do?
A subwoofer is a large speaker built only for low notes, the deep bass your door speakers can't reproduce. It needs a box (enclosure) to sound right, because the air inside controls how the cone moves.
An amplifier takes the small signal from your stereo and turns it into enough power to drive the sub. Then a wiring kit carries power safely from the battery to the amp, with a fuse to protect the car. Put together, these four parts make the bass you can feel.
If you're starting from scratch and also want to upgrade your door speakers or head unit, our earlier guide on how to upgrade your car sound system covers the bigger picture.
RMS vs peak watts: which number matters?
RMS is the power a sub or amp can handle or deliver continuously, song after song. Peak is a short burst it can survive for a split second. So when you're matching parts, always use the RMS figure and treat peak as marketing.
For example, an 800W RMS subwoofer is happiest with an amplifier that delivers somewhere around 800W RMS into the same load. A little less is fine and just means a bit less volume. Far more power, turned up hard, is what overheats voice coils.
Ohms and voice coils, made simple
Ohms describe the electrical load the amp "sees". Most car amps deliver more power as the ohms go down. That's why an amp spec sheet lists power at different loads, such as 100W at 4 ohms and 200W at 2 ohms.
Many subwoofers have dual voice coils, which gives you wiring choices. A sub with dual 4-ohm coils can be wired to show the amp either 2 ohms (parallel) or 8 ohms (series). Two of those subs together open up even more options.
Here's the golden rule. Work out the final ohm load of your sub (or subs) once wired, then choose an amp that's stable at that load and delivers close to the sub's RMS rating there. If an amp isn't rated stable at your final load, it can go into protect mode or overheat.
How to match a subwoofer and amplifier, step by step
- Pick your sub size and RMS. A 10-inch hits fast and fits smaller boots, while a 12-inch moves more air for deeper bass.
- Check the voice coils. Note whether it's single or dual, and whether each coil is 2 or 4 ohms.
- Decide the final ohm load. Choose how you'll wire it, for example dual 4-ohm coils in parallel for 2 ohms.
- Find an amp rated at that load. Look for a mono (1-channel) amp whose RMS output at your final load is close to the sub's RMS.
- Choose the right box. Follow the sub's recommended sealed or ported volume, listed in cubic feet.
- Get a wiring kit to suit the amp. Bigger amps need thicker cable, which means a lower gauge number such as 4 or 2 gauge.
- Set the gain properly. The gain matches the amp to your stereo's signal. It isn't a volume knob, and cranking it causes distortion.
Which amp wiring kit gauge do you need?
The power cable feeds every watt your amp makes, so a cable that's too thin starves the amp and can get hot. Wire size is measured in gauge, and the smaller the number, the thicker the cable. Here's a common rule of thumb used by installers, based on the amp's total RMS output.
| Total amp RMS | Typical wiring kit | Example setup |
|---|---|---|
| Up to about 500W | 8 gauge | An active basspack or a small 2-channel amp |
| About 500W to 1,000W | 4 gauge | One 12-inch sub on a mid-size mono amp |
| About 1,000W to 1,500W | 2 gauge | A bigger single sub or two mid-size subs |
| 1,500W and up | 0 gauge (1/0) | Two big subs, often with the "big three" upgrade |
Copper quality matters too. Oxygen-free copper (OFC) carries more current than copper-clad aluminium (CCA) of the same gauge, so a CCA kit is often best sized one step thicker.
Sub and amp combo or separate parts?
A sub and amp combo (a bundle) is the easiest way in. The pairing is already chosen, so you don't need to work through ohms and RMS yourself. It's no surprise "sub and amp combo" is a popular search for Kiwi car audio fans. Combos also make tidy gifts for the car lover in your life.
Separate parts suit you if you already own an amp, want a specific brand mix or plan to add more subs later. Either way, the rules above still apply, and a good installer will set the gain to match your stereo.
Sealed or ported box: which suits you?
A sealed box is compact and gives tight, accurate bass that keeps up with fast drums and rock. By contrast, a ported box has a vent, so it plays louder and deeper with the same power, which is great for hip hop, reggae and that big boomy doof.
The catch is space. Ported boxes are bigger, so they eat more of your boot. As an example, the Zeroflex FLX-124 recommends about 1.0 cubic foot sealed or 1.8 cubic feet ported, so it's worth measuring your boot before you decide.
Will a subwoofer drain my car battery?
A modest setup running while the engine is on is usually fine for a healthy battery and alternator. Bigger systems pull more current, especially on long bass notes. If your headlights dim on heavy beats, that's a sign the electrical system is working hard.
For high-power builds, people often upgrade key cables (the "big three"), add a second battery or fit a stronger alternator. A good installer can test your system and tell you what it really needs.
Black Friday or Boxing Day for car audio?
For most people, the deciding factor is summer. Getting your system in before Christmas means the bass is ready for road trips, beach runs and long drives up the coast. Installers can also get busy in December, so it's worth booking early.
Black Friday has overtaken Boxing Day as a spending day in NZ, with Worldline recording $55.6 million of non-food spending on Black Friday 2025 against $51.2 million on Boxing Day (Newstalk ZB). Still, if your car is staying parked over the holidays, Boxing Day is another chance to compare prices.
Why professional installation matters
Car audio involves high current, fuses and wiring near airbags and sensors, so it's a job worth handing to a professional. Plus, many Zeroflex subwoofers list professional installation as a requirement for warranty, and you'll need the installer's invoice or certificate if you ever make a claim.
Ready-made setups to start from
If you'd rather skip the maths, matched bundles take care of the pairing for you. Here are four ways in, from simple to serious, plus a few standalone parts. Prices were checked on 19 November and may change as new offers drop.
- The easy upgrade: an active basspack has the amp built in. The Zeroflex EFX-12A packs a 250W RMS amp into the box and includes a bass level controller, so you can adjust the thump from the driver's seat.
- The punchy middle ground: a 12-inch sub with a mono amp, such as the Zeroflex FLX-124 or TKO-12 paired with an FLX800.1 amplifier.
- The double-sub setup: two Zeroflex FLX-124 12-inch subs (800W RMS each) with a DK2000 amplifier. It's one of our most popular car audio bundles, and because the amp has plenty of headroom, setting the gain carefully matters.
- The serious build: the Zeroflex EVO-12XXL is a 3500W RMS competition-style sub with dual 2-ohm coils, made for people chasing big numbers.
Zeroflex EFX-12A active basspack + 8 gauge wiring kit$439
Zeroflex FLX-124 12-inch sub + FLX800.1 amp$499
Zeroflex TKO-12 12-inch sub + FLX800.1 amp$599
Two Zeroflex FLX-124 subs + DK2000 amp$699
Zeroflex FLX200.2 2-channel amplifier$199
Soundtech 2 gauge amp wiring kit$54
Zeroflex TKO-10 10-inch 1000W RMS sub$227
Zeroflex EVO-12XXL 12-inch 3500W RMS sub$749 The FLX200.2 is worth a special mention. It delivers 100W x 2 at 4 ohms or 200W x 2 at 2 ohms, and it can be bridged to 400W x 1 at 4 ohms, so it can power a pair of door speakers or a small sub.
Our Black Friday sale has up to 60% off selected Zeroflex products until Monday 30 November, and you can explore the full Zeroflex range or car audio bundles if you like.
Car audio questions, answered
Do I need an amplifier for a subwoofer?
A passive subwoofer needs a separate amplifier, because your car stereo can't supply enough power for deep bass. An active subwoofer, also called a basspack, has the amplifier built in, so it's the simplest option to install.
How do I match a subwoofer to an amp?
Work out the final ohm load once the sub is wired, then choose an amplifier that's stable at that load and delivers close to the sub's RMS rating. Always compare RMS figures, not peak.
Can too much power blow a subwoofer?
Yes. Far more RMS power than the sub is rated for, or a gain set too high, can overheat the voice coil. Slightly less power is safer and simply means a little less volume.
What gauge amp wiring kit do I need?
As a rule of thumb, use 8 gauge for amps up to about 500W RMS, 4 gauge for about 500W to 1,000W, 2 gauge for about 1,000W to 1,500W and 0 gauge above that. Go thicker for long cable runs or CCA cable.
Is a sub and amp combo worth it?
For most people, yes. A combo pairs a subwoofer with a suitable amplifier, so you skip the ohm and RMS maths and check out in one go.
Is a sealed or ported box better?
A sealed box gives tight, accurate bass in a smaller space. By contrast, a ported box plays louder and deeper with the same power but takes up more room. Follow the box volume your subwoofer recommends.
How much is off Zeroflex this Black Friday?
There's up to 60% off selected Zeroflex products at TechCrazy until Monday 30 November, while stock lasts.